To address the issues of high production decline rate and low recovery rate in the early stage of tight oil development,considering the rock and fluid properties of Fuyu tight oil reservoir, numerical simulation methods were used to study the effects of injection timing and injection pressure on the effect of CO2 huff-n-puff.The engineering parameters were optimized, the characteristics of reservoir pressure distribution and interfacial tension distribution are analyzed,the operability of CO2 huff-n-puff development of tight oil is studied.The results indicate that CO2 huff-n-puff should be implemented when the oil reservoir pressure coefficient drops to around 0.65.At this time,CO2 can fully contact with crude oil,which is beneficial for the dissolution,thereby improving the recovery efficiency.As the injection pressure approaches the minimum miscible pressure,CO2 in a separate phase enters the matrix,making full contact with the tight oil deep within.The dissolved miscible phase improves the development effect.After reaching dissolution equilibrium,the interfacial tension between CO2 and tight oil increases rapidly over time,the time of well shut-in can be determined at this moment.The optimal engineering parameters for CO2 huff-n-puff recovery in this study are:the injection volume is 8000 t,the injection rate is 120 t/d, the injection pressure is 27 MPa,and the time of well shut-in is 30 d. According to this scheme, the increase of crude oil production is calculated to be 3 084 t,and the oil replacement ratio is calculated to be 0.39. The in-situ test of horizontal well also confirms that the application of CO2 huff-n-puff technology in Fuyu tight oil reservoir increased the recovery rate by 1.38 to 3.33 percentage points.The research results are of great significance for further expanding the application of CO2 huff-n-puff technology in tight oil reservoirs.
Yao Tongyu
,
Sun Linghui
,
Cui Chuanzhi
. Optimization Design of CO2 Huff-n-Puff Parameters in Fuyu Tight Reservoir[J]. Special Oil & Gas Reservoirs, 2024
, 31(3)
: 123
-128
.
DOI: 10.3969/j.issn.1006-6535.2024.03.016
[1] 许冬进, 尤艳荣, 王生亮,等.致密油气藏水平井分段压裂技术现状和进展[J]. 中外能源, 2013, 18(4):36-41.
XU Dongjin, YOU Yanrong, WANG Shengliang, et al.Current status and progress of stage fracturing technology in horizontal wells of tight oil and gas reservoirs[J].Chinese and Foreign Energy, 2013, 18(4):36-41.
[2] 梁宏儒,薛海涛,卢双舫,等.致密油藏水平井水力压裂CO2吞吐参数优化[J]. 大庆石油地质与开发, 2016, 35(4):161-167.
LIANG Hongru,XUE Haitao,LU Shuangfang, et al.Optimization of CO2 throughput parameters for hydraulic fracturing in horizontal wells of tight oil reservoirs[J].Petroleum Geology & Oilfield Development in Daqing, 2016, 35(4):161-167.
[3] 周拓,刘学伟, 王艳丽,等.致密油藏水平井分段压裂CO2吞吐实验研究[J].西南石油大学学报(自然科学版), 2017, 39(2):125-131.
ZHOU Tuo,LIU Xuewei,WANG Yanli, et al.Experimental study on CO2 through put in stage-fractured horizontal wells of tight oil reservoirs[J]. Journal of Southwest Petroleum University (Science & Technology Edition), 2017, 39(2):125-131.
[4] LI Sheng,LUO Peng.Experimental and simulation determination of minimum miscibility pressure for a Bakken tight oil and different injection gases[J].Petroleum, 2017, 3(1):79-86.
[5] TORABI F,ASGHARI K.Effect of operating pressure, matrix permeability and connate water saturation on performance of CO2 huff-and-puff process in matrix-fracture experimental model[J].Fuel, 2010, 89:2985-2990.
[6] ABEDINI A,TORABI F.Oil recovery performance of immiscible and miscible CO2 huff-and-puff processes[J].Energy & Fuels, 2014, 28(2):774-784.
[7] PAVEL Z M, YU Wei, XU Yifei, et al.Simulation study of CO2-EOR in tight oil reservoirs with complex fracture geometries[J].Scientific Reports, 2016, 6(1):1-11.
[8] CAO M,GU Y.Oil recovery mechanisms and asphaltene precipitation phenomenon in immiscible and miscible CO2 flooding processes[J].Fuel, 2013, 109:157-166.
[9] 侯广.致密油体积压裂水平井 CO2吞吐实践与认识[J].大庆石油地质与开发,2018,37(3):163-167.
HOU Guang.Practice and understanding of CO2 throughput in volume-fracturing horizontal wells of tight oil[J].Petroleum Geology & Oilfield Development in Daqing, 2018, 37(3):163-167.
[10] 杨正明, 刘学伟, 张仲宏,等. 致密油藏分段压裂水平井注二氧化碳吞吐物理模拟[J]. 石油学报, 2015, 36(6):724-729.
YANG Zhengming,LIU Xuewei,ZHANG Zhonghong, et al.Physical simulation of CO2 throughput in section-fracked horizontal wells of tight oil reservoirs[J].Acta Petrolei Sinica, 2015, 36(6):724-729.
[11] MONGER T G,COMA J M.A laboratory and field evaluation of the CO2 huff-puff process for light oil recovery[C].SPE15501,1988:1-11.
[12] ZHANG Y P,SAYEGH S G,HUANG S.Laboratory investigation of enhanced light oil recovery by CO2 fuel gas huff and puff process[J].Jounarl of Canadian Petroleum Technology,2006,45(2):24-32.
[13] ABEDINI A, TORABI E. Oil recovery performance of immiscible abd miscible CO2 huff and puff process[J].Energy & Fuels,2014,28:774-784.
[14] IRAJI B,SHADIZADEH S R,RIAZA M,Experimental investigation of CO2 huff-puff in a matrix fracture system[J].Fuel,2015,158:105-112.
[15] BO R, LIANG Z, HUANG H, et al.Performance evaluation and mechanisms study of near-miscible CO2 flooding in a tight oil reservoir of Jilin Oilfield China[J].Journal of Natural Gas Science & Engineering, 2015, 27:1796-1805.
[16] ZHANG Z, HE S, GU D, et al.Effects of stress-dependent permeability on well performance of ultra-low permeability oil reservoir in China[J].Journal of Petroleum Exploration & Production Technology, 2017,36(7):1-11.
[17] 国家石油和化学工业局.液态二氧化碳吞吐推荐作法:SY/6487—2000[S].北京:石油工业出版社,2001:1-5.
National Petroleum and Chemical Industry Bureau.Recommended practices for the handing of liquid carbon dioxide:SY/6487-2000[S].Beijing:Petroleum Industry Press,2001:1-5.
